Photography by Peter James

 

This is a sample corset that was made to test some new techniques. It has been worn only once for a photo shoot and is in very good condition.

This corset has shaped cups and a sweetheart neckline. It has a slightly pointed front with a gentle curve down to the back. It features an attached back modesty panel with vertical boning and has been designed with a 5cm gap in mind.

It is made from chocolate duchess delustered satin with cream duchess satin contrast boning channels. It is bound in chocolate duchess satin and has white size 00 grommets.

**There are a few small white marks on the front of the busk that appear to have come from the grommets while the corset was being stored. They are not very noticeable.

Fully closed at the back, this corset measures as follows:

Front Length - 32.5cm (12.75")
Bust - 89cm (35")
Waist - 60cm (23.5")
Hip - 82cm (32.25")

This corset has been designed to have a 5cm (2") gap at the back.

**Due to the bust shape it would best suit a DD-E cup to avoid gaping at the top. (Padding could also be used to push up a smaller bosom).

Please contact me if you would like more detailed measurements.

This corset features:

• Front modesty panel behind the busk.
• Attached back modesty panel with vertical boning.
• Waist tape.
• Combination of sprung steel and spiral steel. 22 bones in total.
• Triple-stitched seams.
• Woven interfacing fused to fashion fabric for extra strength.
• Two layers of cotton drill as the strength layer and lining.
• Two-piece white grommets (size 00).
• Strong black poly-cotton lacing. ( If you would like cream satin ribbon please add $8 to the cost).

Cream satin ribbon can replace standard black corset laces for an additional $8.

Please email me for a direct purchase.

Postage is $12 within Australia, $15-21 international, depending on destination.

You may request registered post for an extra charge.

Payment by bank deposit if in Australia, otherwise PayPal.